182mm X axis full print bed upgrade Printrbot simple 1405 makers edition 2015

thingiverse

This upgrade now utilizes 182mm of the complete x axis of the print bed:-)!! I downloaded the latest update (link below), but it was for a different version, so I designed this one to work specifically with my Printrbot Simple. The update mentioned is redesigned to fit the Printrbot Simple that I own from December 2014. To ensure ease of installation and print quality, I added an x-axis zero-stop screw and belt tensioners to each side of the upgrade. This can be printed on a Printrbot Simple 1405. http://www.thingiverse.com/thing:215294 Instructions: You'll need at least 7" (175mm approx) more GT2 Belt than the rods you plan to use. Two eleven-inch, eight-millimeter rods should provide sufficient length to utilize the full printbed. However, getting the full 182mm is key: simply counter bore the printbed screws and you're ready to go! If not, you'll be limited to around 150mm due to the extruder and sensor hitting the print bed screws. I used Phillips countersunk three-millimeter screws that are fifteen millimeters long. Next, level the bed after tensioning the belt. Once the upgraded printbed is assembled, it's time to change your printer settings: 1. Your slicing program 2. The Repetier-Host printer shape in printer settings 3. Your printer board Changing these settings will be a breeze. With your printer turned on and connected to Repetier, navigate to the manual control tab, type M211 X(new print bed size in mm) and hit send (for example: M211 X150 for a 150mm x-axis). Then, type M501 and hit send. The new print values should appear at the bottom of the screen. If you don't see the log, press the toggle log button next to the kill print button to display it. After reprogramming your printerboard, disconnect from Repetier and restart both the printer and Repetier-Host. Then reconnect the printer and enter M501 once more. Verify your expanded printbed size in the log and enjoy printing!