180 Degree Elliptic U-siphon for 1/2" PVC

prusaprinters

I was not too happy with having so many parts just to make a u-siphon so I designed this. I think it works a bit better than a standard u-siphon from pvc elbows, but I'm sure it depends on your input flows and exit pipes, like with most siphons.The "theoretical" sizes were really tight from the filament I used, so I messed around and determined the 103 scale was right for my printer to fit 1/2 inch PVC.I had fun designing this, so I plan on designing some more special elbows, etc. If you have a request let me know I'll take a look.If you like this design and use it and enjoy it's use, please consider coming back and giving a tip! I am a creator, so I like to know my time designing for Thingiverse and makers is well spent and could use the dollars. Or check out my Etsy! HutchisonCurioStudio.etsy.comPrint SettingsPrinter:SnapmakerRafts: Doesn't MatterSupports:NoResolution: .2Infill:70Filament:Geeetech PLAWhite Notes: No supports required. I recommend thick walls and decent infill since this part will be used and you want it to hold up.  Category: Hobby