16mm Wood Tee Connector

thingiverse

My initial post was a corner connector that served as the starting point for this tee design, which was specifically requested by someone. I had previously used these fittings to create retrofitted shelving in the back of our kitchen cupboards because it was challenging to screw into the inside of the cupboard and assembling the shelving to fit within it seemed impossible. Despite allowing space for screws in the fitting, I chose not to include any, and yet the brackets have managed to hold the shelving together thus far. Print Settings Printer Brand: FlashForge Printer: FlashForge Creator Pro Rafts: No rafts were used. Supports: None were required. Resolution: The print resolution was set at 0.2 mm. Infill: A relatively low infill percentage of 10% was selected.