15ml falcon tube holder x6

myminifactory

I needed a holder for six 15 milliliter Falcon tubes that was more precise than the one I was using. It was too big and didn't allow two tubes with caps attached to fit side by side, blocking the scales on the tubes. This new design fixes these issues and saves me valuable bench space. This project started in the browser version of Fusion360 before being refined in the installed program. Unfortunately, this resulted in a broken linear pattern, which is only noticeable when the pattern is altered. I apologize for any inconvenience caused by this oversight. Version 2 of the design should be easier to edit within Fusion360 and requires less material than its predecessor. Additionally, it addresses a problem with Version 1: pushing down on the outermost tube would cause the entire rack to pivot around the foot, rendering it unstable. Licensing: If you wish to sell this design, please contact me directly. If you operate a printing service and are asked to print this holder, feel free to do so, although a tip would be appreciated for your time and effort.