15-Block Rokenbok Beam for MakerBot Replicator 2

thingiverse

Customized version of http://www.thingiverse.com/thing:322722 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=322722 The supports are designed for single extruder printers for minimal, easy to remove (with needle-nose pliers) supports. Be careful when removing the supports (wear safety glasses!), PLA shards can be sharp. Tested with the following setup:Printer: Replicator 2 (PLA)Layer height: 0.2mm These designs are owned by Rokenbok Education (http://www.rokenbok.com) and published under license by kid*spark (http://www.kid-spark.org), a nonprofit corporation, for nonprofit and educational uses. Drawings of these designs are licensed under Creative Commons Attribution-NonCommercial-ShareAlike (BY-NC-SA) 3.0: http://creativecommons.org/licenses/by-nc-sa/3.0/ The drawings may be freely downloaded, modified, and used, providing that attribution is given to Rokenbok Education and the drawings are for non-commercial purposes. Any modified drawings are licensed under the same terms. The drawings are intended for educational and hobby uses only; 3D prints of these designs should not be considered toys or for use by children without adult supervision. The drawings are not guaranteed to print perfectly. Instructions Using the following options: supports = 1 number_of_blocks = 15 support_thickness = 0.2 female_snap_fit_tolerance = 0.2 male_snap_fit_tolerance = 0.3 snaps = 2