15" (38 cm) Fabric Pot Stand

prusaprinters

<p>Since having your plants standing in water is not a good idea, I designed a stand to solve this issue. None of the commercially available ones were very good, either not high enough or not sturdy enough, or made of metal with shitty chrome plating.</p> <p>I experimented with different sizes. At first I thought a 60 degree segment would be nice, if you could place two on the print bed you'd need 3 prints to get one stand, but that did not work out as planned. So I switched to a 90 degree design that just barely fits on a Prusa i3 print bed, if you print without a perimeter.</p> <p>You need to print four to get one stand. They interlock with just a little bit of play.</p> <p>If you want a smaller size, you can scale the file in Slic3r or Cura. At some point, the interlock features will probably stop working because they become too small to print. I did not try this out so don't blame me if it doesn't work.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>I3 MK3S</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.3 mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>20%</p></div> <p><strong>Filament:</strong> any PETG any</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>I printed 3 perimeters but 2 is probably fine as well.</p></div> </p></p></p> Category: Outdoor & Garden