1405 Simple X Ends - Max Stock Bed Size

thingiverse

This is a custom remix of the original PrintrBot 1405 stock, specifically crafted to maximize every usable inch of the bed. By attaching these extended X ends to the Z axis rods, you can seamlessly extend the X size of the bed up to 145mm in no time. For comprehensive instructions and supplementary components necessary for this upgrade, be sure to visit the original thing on http://www.thingiverse.com/thing:376515. In addition to this X-axis extension, you will also find included some vital bed spacers that have been thoughtfully designed for optimal use with an E3D hot end. Note that since this hot end is significantly shorter than the standard Ubis stock, these spacers will stand out a bit due to their considerable height. Don't worry; they are easy to trim down to size if you don't require that extra vertical space. To take full advantage of your newly expanded bed area, remember to install M3 30mm countersunk screws. And for maximum benefit, don't forget to sink the screw heads as well - this subtle detail will greatly contribute to maximizing your work surface.