12v 5A 60W Power PSU Enclosure

thingiverse

This is a power supply box designed for a 12v 5A PSU. I built it to power LED strips on my 3D Printer. The back features a cutout for a 120/240v IEC320 C14 power cable inlet, which is the same type used in computers. A power switch is also integrated into this design. On the front, there are six DC Power Jacks. For ventilation, the top has several slots cut out. The bottom of the box has two holes for mounting this exact PSU using m3 x 5mm screws. However, I'm not sure if it will work with other PSUs from different vendors. The fit is snug, so it might just sit in there by friction alone. Another option would be to use double-sided tape or hot glue along the top edge. The back panel snaps into place when printed, but some light sanding or scraping may be necessary to get a perfect fit. If it's too loose, you can always use hot glue to secure it without making it permanent. In the future, I might add a magnet securing system for the back panel. This design was created in Fusion 360. The power inlet is offset because I didn't feel like re-sketching and modeling the back. Originally, the DC jacks were on the same side as the power inlet, but I wanted room for expansion, so I moved them to the front to have six instead of four. Parts used: * Power Supply: https://goo.gl/ro6uT8 * IEC320 Power Input: https://goo.gl/JKEiHR * DC Power Jacks: https://goo.gl/jh1C30 * DC Power Plug: https://goo.gl/FzvrqG Print Settings: Printer Brand: Wanhao Printer: Wanhao Duplicator i3 V2 Rafts: No Supports: No Resolution: 0.25 Infill: 20%