12t 8.1 shaft

thingiverse

Instructions Using the following settings: motor_shaft is set to 8.1 one idler has been chosen additional_tooth_depth is disabled by default a 3.1 mm m3_dia diameter screw has been selected the nut_angle has been set to 90 degrees nut_shaft_distance has been adjusted to 1.2 pulley_t_ht has been adjusted to 13 no_of_nuts has been set to two pulley_b_dia is currently at 25 retainer_ht has been set to 1.5 mm pulley_b_ht is at its maximum of ten millimeters additional_tooth_width has been disabled by default m3_nut_flats have a width of five point seven millimeters profile selection has chosen the value ten retainer usage has been opted out a 1 m3_nut_hex length hex bolt has been picked for screwing and unscrewing purposes only 12 teeth are to be included the idler_height (idler_ht) is currently at one point five millimeters m3_nut_depth, a metric diameter with 2.7 as the maximum allowed, was left default at its standard setting.