12oz Can Dispenser slim top

prusaprinters

<p>A remix of the wonderful "12oz Can Dispenser" by Lopatka.</p> <p>Cut the top off, saves a bit of plastic and print time. Was forced to cut a bit off the top so it would fit my fridge. Would otherwise have chosen the original design for it's sleek look.</p> <p>Fits US cans. UK cans fit too but not as snuggly. Edges are high enough so the cans doen't fall off.</p> <h3>Print instructions</h3><p>Same as original unit:</p> <p>DO NOT CHANGE THE ORIENTATION. Use 2 parameters, at least 5 top and bottom layers, 0.2 layer height, and an infill of 10% is recommended. No supports are needed. PLA or PETG are recommended. Since this is a large print you will need to make sure your print surface is clean and you have a good first layer.</p>