12864 lcd screen mount

thingiverse

I designed a custom holder to accommodate my Tronxy X5S's 12864 LCD screen, as I wasn't satisfied with its placement in the bottom corner. Other prints were in line for production first, so it hasn't been printed yet. This design should attach securely to the 2022 rail or can be mounted anywhere desired with a few screws. To install this, you'll need four factory M2 bolts and two additional 10-12mm M2 bolts and nuts on one of the back pieces, along with two M4 bolts and T-nuts (which could potentially come from the original LCD mount). There's also an optional single hole mount that can be used, which might alter the required bolt count. I utilized five M5 30mm bolts and nuts for the arm. UPDATE 10/29/17: After printing a new back but running out of filament mid-print, I was unable to check fitment precisely regarding depth and full enclosure case fitment. However, all mount bolts were perfectly aligned; no adjustments were needed there. I did shift the cable opening about 1 mm to the right as it wasn't perfectly centered. I'm confident this design is ready for use now... please download the updated files and print away! I added a second file for the front panel, considering the SH has a smaller hole for the knob; I didn't feel like perfecting it since the knob would cover it up anyway. I recommend printing that one instead. I also included a single-hole version of the mount for frame-side mounting option. UPDATE 10/27/17: Upon reviewing yesterday's files, I noticed the top two mounting holes were about 2mm too high; today's files correct this issue. UPDATE 10/26/17: I addressed all measurement discrepancies and chose to make the bolt holes through the mount bracket 5mm instead of 8mm. UPDATE 10/26/17: Everything should be accurate now, but I still haven't printed it yet – it might arrive tonight. UPDATE: After receiving a comment stating that this design is significantly off, I will verify and update later tonight. The commenter mentioned that the screen opening was too long and my factory-opening dimensions are 81mm x 52mm, while my design's opening measures 81mm x 53mm – they're pretty close. However, the knob was off by 2mm, and the mounting holes were way off... I will correct this and upload new files tonight.