125mm nut for spool holder

thingiverse

Instructions Using the Following Options: Created by Thingiverse Customizer at http://www.thingiverse.com/apps/customizer/run?thing_id=193647. 1) Select the following specifications: nut_resolution: set to 0.5 mm. nut_thread_step: established as 1 step per revolution. nut_diameter: configured for a 12mm diameter size. step_shape_degrees: aligned with 45 degrees. head_diameter: adjusted for 15mm maximum outer size. nut_thread_outer_diameter: measured at 8.4mm from thread outer circumference. head_type: socket is preferred design. inner_diameter: established as an inner size of 8 mm diameter only. thread_length: determined as a full length engagement depth of 125mm nominal measurement length only and with non threaded part not to exceed a specified depth. thickness: calculated for material requirement as minimal thickness value used equaling only 2 millimeter exact thickness. nut_step_shape_degrees: same configuration established also in step size, that is equal at forty five degrees identical degree setup on same thread also for this instance thread_outer_diameter = thread_step diameter non_thread_diameter : defined no other specified inner diamater size or shape nut_type = standard nut_height = measured 10 mm head_height : adjusted a socket of type nut only set up.