125mm Leg for CR-10

thingiverse

Legs for the Creality CR-10. Designed to replace the 3 bolt leg plates that come standard with the printer. Check the bolt layout on your printer before starting to print. The legs measure 125mm tall, 55mm x 40mm at the mounting plate, and 18mm x21mm at the foot. A print time of 5 hours, 4 minutes is required for completion at a layer height of 0.2 with 40% infill. Material usage amounts to 45g and 14.85 meters. These legs provide enough clearance for the control unit to sit securely under the printer. It's highly recommended that you add non-slip rubber pads to prevent the PLA material from sliding on slick surfaces. No additional hardware is needed aside from these legs. A print for half-millimeter thick shims is included to aid in printer leveling. The shim measures 18mm x 21mm x 0.5mm. The shim takes only 21 minutes to print at a layer height of 0.12, using a total of 2g and 0.52 meters of material. For optimal results, it's recommended that you print the legs on their side at a 90-degree angle with a 40-50% infill for structural integrity. When printing the shims, use a high resolution to prevent thin spots from forming.