120mm fan shroud for multi GPU setups

cults3d

I have been attaching a fan to the end of my tri-sli'd gpu's since I first got my 480's. The 3d printable bracket I modeled for the 680's doesn't work so well with 780's in an 800D, so I hadn't been using it. The 780's are just a tad longer, and the fan would have been right up against the sata connector cover on the 800D. After playing Farcry 3 for a few minutes on the new setup, I was surprised to see my top two cards were hitting 79 degrees, while my bottom card never got over 60. Coming from the cool 680's, this wasn't good enough, and the cards where obviously suffering from suffocation. I modeled and printed a new version that tilts up and draws in air from the empty 5.25 bays. Bottom one still stays as cool as ever, and the top two stay in the mid to high 60's.