120mm computer RGB ring fan shroud

thingiverse

This completely replaces the original fan shroud. You will need to cut off the original fan shroud and glue it onto the new shroud. Do note that you should keep the piece of shroud that the motor is attached to and glue that to the new part. i do not take responsibility if you damage any components. this shroud is a bit bigger then a normal 120 mm fan (about 5 mm on the edges and 4 mm thicker) so check measurements on the case that you plan on using. also, depending on the donor fan blade if mounted face first to n grill it might rub so will possibly need a spacer of some sort. The ring part presses directly onto the shroud and there is a gap between the actual shroud and the ring that will fit most RGB strips, i used IP65 RGB strip. You can also use this without the actual LED strip and print the ring in a nice color. no support needed for any of the parts.