12 volt flashlight

thingiverse

This is a 12 volt flashlight. Contents: 2 screws bottom hull socket cover reflector lid What is needed: Light bulb (The one this is designed to house is a H4 12v light bulb, but it can be replaced with an LED, if the LED circuit is used.) Power supply (The one this is designed to house is a Euroglobe EG1.3-12 battery, but this lamp is designed to be able to house any power supply that fits in a 55x42x92 mm area.) Switch (Any switch that fits in a 11x29 mm square hole should work.) An 88 mm diameter glass plate (Any translucent plate with the diameter of 88 mm should work.) Note: this part isn't necessary, and can be left out if needed. Some wire (a 25 cm long wire should be enough) The lamp can be built with the LED circuit or the bulb circuit. Note: If the LED circuit is used, the power supply should be switched to one that has a voltage that is compatible with an LED. Measurements: 203 mm, 97 mm, 107.5 mm WARNING: Not designed to be used for long periods of time. If this lamp is left on for too long, the heat created from the light bulb WILL melt the plastic creating a potential fire hazard. (Unless the LED circuit is used.)