12 foot Skeleton and Inferno Replacement Arm Head Bracket Adapter

myminifactory

AVAILABLE FOR PURCHASE HERE: https://www.etsy.com/listing/1240595620/12-foot-skeleton-and-inferno-replacement UPDATE 7/14/22: Uploaded a new clips for the Inferno adapters, the other clip were a bit too short (V3_Arm_Adapter_Clip_Inferno.stl, V3_Arm_Adapter_Clip_InfernoR.stl). UPDATE 3/12/22: Uploaded a new clip for the Inferno Right Arm adapter, the other clip will work but this one will lock in better (V2_Arm_Adapter_Clip_InfernoR.stl). UPDATE 11/9/21: I've added replacements for the Inferno Pumpkin arms as well. There is a specific left and right version. (These are untested, but should line up just fine). UPDATE 9/28/21: I've released a 2nd version that better locks in and has a slightly thinner plate. Version 1 didn't lock in as much as I'd like. Please download and use V2 files. This is meant to replace the broken adapter on the lower part of the arm of the Home Depot 12 foot skeleton. Make sure to print 2x of the clips and orient them on the print bed as shown in the pictures. This is to have the layer lines in a direction for maximum strength.I have test fitted this and seems to work but your printer settings may alter the size a bit. Hardware required; 4x M3x15 screws (or similar) Let me know how it goes and I can try to make changes if needed. I recommend PETG or ABS especially if you are in a warmer climate as PLA may deform.