1157 Housing for SA22C/FB Rx-7

thingiverse

Use the 3mf, the stl's settings might be off. This is an untested housing for the side marker(?) light on the 1st gen (SA22C/FB) Rx-7. I realized after making this that it is not a required light where I live, so I ended up not printing it. Theoretically, it should fit, so long as you have the orange plastic bit that goes over it. You can buy an 1157 Bulb Socket on Amazon, it should fit in the hole in the center. You will need to glue it down somehow, my plan was to use some form of epoxy. Make sure whatever glue you use does not get into the spring mechanism for the socket, otherwise you will no longer have a usable socket. Make sure you print in some high temperature filament, otherwise it will melt or deform fairly quick, as it's very close to the engine bay.