110 Film Holder for Epson V600

prusaprinters

Edit: You may want to use this model instead, because I've since tweaked it a bit to include some support at the bottom of the negative to keep curved bits flat, among a few other things. I'm keeping this one up in case they'd rather use this version.I took Thinbegin's excellent 110 film holder for flatbed scanners and knocked off something like 2 mm to get it to fit the “B” plate in an Epson V600 perfectly.I tweaked it because out of all of the holders I tried, this one was the most sturdy and the magnets made for very easy placing/securing of negatives. They've got a “short” remix available, but it's a bit too short for me. This version will fit the large rectangle in the “B” plate perfectly if you pull off the hinged piece (Non-destructive, it pops right off), so it allows for perfect placement of the holder underneath the film scanning portion of the printer.I'm not even sure if this counts as a remix, honestly, but I figured worst case I could save someone a trip to tinkercad or whatever to get it working on their printer.I doubt settings matter a ton - there are no overhangs if you print the pieces with their flat bits on the surface of the printer. Took me about 5 hours at .2 layer height