10T

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following settings: teeth are set at ten units pulley height is thirty degrees m3 nut flats are 5.7 millimeters deep retainer height is one and a half millimeters nut angle is 180 degrees clockwise pulley base diameter is twenty millimeters an idler bearing is not installed additional tooth width is point two zero millimeters motor shaft size is eight and two tenth millimeters a retainer is not in place profile thickness is six hundredths of a millimeter m3 nut diameter is three point two millimeters m3 nut depth is two and seven tenths millimeters idler bearing height is one and a half millimeters pulley tooth height is twelve millimeters additional tooth depth is zero units distance from shaft to m3 nut center is one point two millimeters there are two M3 nuts used