101Kossel Conversion

thingiverse

This is an attempt to convert the $99 101Hero Kickstarter printer into a modified Kossel Mini reusing as many of the 101Hero components as possible printed on the 101Hero, with size restrictions under 110mm in diameter and under 100mm tall. Note: This conversion requires upgrading the tower motors to NEMA17, but it should be possible to reuse all other components, including the extruder, belts, steel rods, push rods, linear bearings, controller, etc. Current 3D Printed Bill of Materials: * 3 frame top * 3 frame bottom * 33 75mm 2020 rails * 54 rail connectors (M3 or M4) * 90 25mm inner-fill * 3 or 6 end caps (optional) Extra Hardware Needed: * 54 M3 or M4 nuts (size determined by rail connectors) * 54 M3 or M4 x 4mm screws * 36 M5 nuts * 36 M5x10 hex bolts If you prefer to use M3 or M4 bolts, T-Nut models for M3 and M4 nuts are included. Washers may be required for smaller bolts.