100mm VESA Offset (40 & 47mm offset) Adapter

thingiverse

I have two unique monitors (one for gaming and a secondary monitor) whose VESA mounts were nowhere near aligning properly. I created this adapter to solve that problem. The 40mm offset fits perfectly on an Ender 2 bed, but the 47mm did not fit at all. This design is specifically intended for use with certain hardware: - Four twenty-millimeter M4x0.7 hex bolts - Four M4x0.7 nuts (I used wing nuts) - Four twenty-five to thirty-millimeter M4x0.7 screws and M4 washers When using longer than thirty millimeters of screw, be extremely cautious as it may bottom out in the monitor and cause damage. Hand-thread the screw before torquing it down to ensure there won't be any issues. The hardware is a very tight fit; you might need to drill or hammer it into place depending on your printer's oozing characteristics.