100/75 VESA Adaptor

thingiverse

This is a simple replacement adaptor to mount a VESA100 monitor to a VESA75 bracket. The inner holes may be specific the the VESA75 mounts we have, the tips of the brackets are 100mm wide with rounded end and screw hole and about 2mm thick. In our case the bolts were missing as well, I found that M4 x 12mm cheesehead bolts worked just fine. Print Settings Printer: Turnigy Fabrikator Mini V1.5 Rafts: No Supports: No Resolution: 0.2mm Infill: 100% Notes: I printed this item on it's side without support as most machines can bridge a 2mm span easily and cleaning the support out of the inside would be way too difficult. Set your perimeter layers as high as possible so the item will end up solid, printing on it's side puts the highest strength in the direction needed for load bearing but keep in mind that if the adaptor is too tight over the VESA75 bracket it could cause the adaptor to split and fail likewise don't over tighten the bolts into the VESA100 monitor for the same reason. I made mine in PLA and they were plenty strong enough, PETG or ABS should also be suitable however with ABS make sure your machine is achieving good layer adhesion.