10 x 30-06 Extended Magazine for Browning X-Bolt Stalker rifles.

cults3d

This is my new 10 x 30-06 Extended Magazine for Browning X-Bolt Stalker rifles. The model is completely reworked with all my knowledge of my previous made magazine. The model is more printer friendly, with less overhangs. Support configuration: Overhang Threshold 75 Post Diameter 2.0mm Base Diameter 6,0mm Base Height 2.0mm WARNING!!! With the new Follower its possible to load more than 10 rounds. Be aware! Loading with more that 10 rounds, will most certain damage your spring!! For best results print in high resolution with 60% fill. You will also need: Spring/Roll pin (2x20mm) https://www.amazon.com/Neiko-50412A-Assortment-Storage-Pieces/dp/B076B4WT1V 4mm compression spring https://www.amazon.com/uxcell-0-4mmx4mmx10mm-Stainless-Compression-Springs/dp/B076M55S7F Feeler Gauge Tape 0.40 mm. See Picture https://www.amazon.de/-/en/Feeler-Gauge-12-7-5000-Weight/dp/B00AZK3W00 The total length of the spring, before it is bent, should be 24cm. Each length should be 6 cm and the bends must not be sharp but must be slightly rounded. If the bends are sharp, the spring loses its ability. Start by marking the middle of the spring (approximately 12cm) I made a jig for this but you do not have to do it if you are not going to do many. Bend the spring at the 12cm mark over something around, for example a screwdriver. Then repeat this at the other markings. Each bend should hold about 63 degrees in the released position.