10 Inch Saw Blade Carrier

thingiverse

This is a basic carrier for a 10" table saw or chop saw blade. The main body is 300mm x 280mm so you need a pretty sizable print bed. You'll need 3x m4-0.7 heat set inserts and 3x m4-.7 x 6mm socket cap screws.The heat set inserts are set into the three holes in the main body. One of the screws goes in the thumb wheel retainer and the other two fasten the lower lip piece into place. Edit: Reduced the overhang of the lower lip; enlarged slightly the holes for the cap set screws; revised the shape of the lower lip.