10.5mm Nut

thingiverse

Using the following options: nut_step_shape_degrees is set to 45 Thickness comes out to 2 millimeters The resolution is turned up to 0.5 millimeters per notch Slot width has been standardized at 1 unit wide The ratio of wings on the top has been adjusted to fit within the given proportions Choosing the default nut design as 'normal' Non-threaded area diameter has been set to 0 The step increment is increased by two times at every stage in threading for enhanced support Design type is a basic nut that meets our fundamental requirements No extra length is required for non-threaded zones, leaving room for adjustments according to needs Head Height Has Been Set To An Ideal Height of Five Millimeters Nut height measured as twenty millimeters has been left unchanged The diameter of the head on top has been standardized at 12 millimeters. It has chosen socket-driven types only for ease and accuracy Drives diameter stands out, optimized at a diameter size of five millimeters Default choice is given preference over customized designs in choosing a standard diameter with value 'nut' of fifteen millimeters No intricate details or patterns have been included Prefer the default type and keep its parameters intact by maintaining an original design that looks exactly like its base structure. The hex head configuration has no need for modification at this stage. It has taken outer dimensions, specifying it should not go beyond fourteen in overall diameter, with outermost end size left to 10 point 5 for extra thread Countersinks will hold a moderate amount of three Incorporate an average and rounded inner radius with standard internal measurements defined within eight millimeters only. The level of precision desired has been established to half unit sizes. To define each surface and smooth out facets as required, select number six for general details as final step