1/35 scale trailer for the Orlandoo Hunter

thingiverse

Here is a small trailer for the Orlandoo Hunter. I designed it using leftover parts from my Orlandoo Jeep kit. What you'll need: 5 pieces of OHSW01505 screw (4 for the axle carrier and one for mounting the towbar to the truck's rear bumper), 1 piece of OHSW01205 screw (for the ball end), 1 piece of OHMLA20162 ball, and a corresponding ball end. Additionally, you will need 2 small wheels, up to about 31mm OD in size, a 2mm rod for the shaft, and some 2.5mm spacers between the wheels and the trailer on the shaft. Some more details: I used a pair of Losi Micro-T front tires to mount it, requiring a 2mm steel shaft, about 62mm long, with 3mm thread on each end. You can also use an M2 threaded rod as an alternative. To install the wheels, I placed them inside out, which made the trailer narrower overall. A 2.5mm spacer was needed between the wheels and the trailer on the shaft to prevent rubbing against the wheel arch. Finally, two M2 nylon locknuts were used to secure the wheels to the axle. The ball end was reinforced with a bit of superglue around the 1205 screw for added stability. To mount the towbar, I drilled a 1mm hole in the middle of the rear bumper.