1/2 inch thread bike pedal

thingiverse

I'm going to replace the stock bike pedal with a new one instead of spending $20 at Walmart. I designed and printed my own pedal, choosing to use PLA with 40% honeycomb infill for the first print. Unfortunately, it snapped in half after about two months due to cold weather, which is a common issue with PLA. For my second print, I opted for Taulman 910 nylon with 35% honeycomb infill and was blown away by its incredible strength. This pedal should fit perfectly on all Kent KZR pedals that use 1/2 inch thread. Print Settings: Printer: BigXY Rafts: No Supports: No Resolution: .20mm Infill: 30% Notes: Turn off the fan for nylon until the top layers, then turn it back on at 10% for a smooth surface finish.