1:100 Scale 2S1 Carnation Artillery

thingiverse

To be honest, I don't remember what the original model was for this for correct attribution as I started this project a while back but it is not an original design of mine. But as usual, I've added a lot of detail and corrected some bits. Cannon is a separate piece so it can be placed at any angle. Do take special note of the tail gate cages on the rear of the hull and the folding cage on the back of the turret. They'll require small supports correctly placed (don't auto generate supports here) but also be careful when removing those supports as these bits are extra delicate until you cure the print. I opted to not make an open hatch version of either the turret or hull as if these are launching arty rounds, no crew member in their right mind is going to not be buttoned up inside. As always, enjoy! And I always appreciate feedback on these models.