1/10 scale truggy rims

pinshape

Summary: Huge Rims for the Truggy Need to be Enlarged Ten Times. They Fit Tires Bought on Ebay for $12 but Didn't Clear the Chassis, So I Made These. They Are 62mm Wide and 29mm Deep in Front, with Rear Being Deeper. Supports Needed for Printing and I Used a Two-Layer Raft. Instructions: Printed Ten Times on a Kossel Delta with Support from a Two-Layer Raft. Perimeter Layers Were Four and Same for Top and Bottom, with 0.3 Layer Thickness. Fill Was 50% Hex and I Used Slic3r.