1/10 scale tie down chain hooks and binder

thingiverse

This model scales better with chains, the binder isn't to scale, but it works and looks good. The chain is as small as can be printed without a lot of problems, so no, it's not exact to scale. Print this on a raft. The binder parts and hooks need to be printed on a raft with supports. For the binder hinges, use 1.75mm filament if you made it with ABS; use acetone to glue the parts. The outside end hinges for Arm 2 I found that putting the filament through the hole in one piece using acetone, then use your dermal to cut the middle out after it has set. Then you can cut the pieces just a little longer than the width of the Arm 2 holes or flush. If you cut a little longer than necessary, you can take a hot butter knife and tap the ends like using a ball peen hammer to round the ends to keep the arms from coming off. This isn't necessary as I've found they stay pretty well without doing this; it's just an added process if you're worried about that. The flat bed will be posted soon, I know I said I wasn't going to do a flat bed but I had so many issues with the one posted here on Thingiverse. It is finished and I'm just deciding whether or not to add storage center sections for chain storage.