1-10 RC Hoonicorn Hoonicorn Intake Bonnet Insert Design by SlantedRC

grabcad

Design inspired by the infamous Hoonicorn Mustang driven by Ken Block in the Gymkhana series. I've split the design into two pieces, hoping this might alleviate some potential issue during the printing of the item. The blower section needs to be superglued to the base to secure it.I recommend trimming a hole in the bonnet area and either glueing the part to the inside of the bonnet with lexan-compatible epoxy, or with 1-2mm thick double-sided tape. Personally would recommend using tape instead of glue to avoid damaging the paint, and the small gap between the throttle bodies and the body might just add that extra touch of realism.I'm keeping my fingers crossed that these items will come out 100% on the first go, but if there are any issues whatsoever, please reach out and let me know so I can fix whatever needs fixing.Product is yet to be printed, tested and reviewed, and potential flaws on drawings may still need to repaired. I rely on your feedback to fix any issues with any of my designs, and appreciate any and every comment you can provide - THANK YOU IN ADVANCE.Should you have a custom request, please get in touch. I will gladly assist where and when it's possible.This design was published to be used and printed free of charge and not to be distributed or sold for profit. (My contribution to RC Hobbyists to try and keep it as affordable as possible). Printing, installation and usage is done at your own risk.Please post a photo of your installation on our Facebook and Thingiverse wall if you opted to use the design.Facebook: https://www.facebook.com/SlantedDriftSquad/