05-02_0333 Pacman

thingiverse

Enjoy the fight as this keychain blasts out from your printer, crafted with reckless abandon using PrintShop ShapeMaker and a healthy dose of cartoonish flair! Get ready for the excitement as every intricate detail pops to life. Here are the step-by-step instructions to make it happen: Blur everything just that bit, 5 degrees at a time Scale up or down to size, just a smidge more with each pass - let's say a factor of 2.48 is the magic number Give it some serious heft, so the keychain sticks out and refuses to back down - make it a proud 15.5 units tall Don't worry about alignment, we're making this a DIY kind of project - shift that X axis over by a whoppin' 252.51 units Similarly with Y - a dash of 453.62 is the trick here, get used to seeing numbers this size Where it all begins: set your coordinates for x and y with x0 at 1.94 and y0 right under that at 1.5, just waiting to burst forth! Make sure we've got enough height left over for a healthy dose of action - no worries about going too deep into offset land here; offsetHeight's nice and calm at zero. Choose your background wisely: let it shine with all its glorious radiance like a ray of sunshine; backingType's where you make this happen Finally, we've got our endpoints in place for x and y with x1 set firmly at 337.59 units on the x axis - take it from here and aim for y1 at an incredible 498.92 This is crucial: know exactly how far you're willing to push the limits of what's normal; the threshold is where this begins, after all, sitting precariously low at .96 points above our minimum