zumspot 3d models

Had been looking for a way to rackmount a Zumspot, and hadn't found anything, so decided it was time to learn how to play with 3D modeling a little bit. I remixed phxt's design, which provided an excellent starting point. Enlarged the view hole to...

A reimagined remix of the lid from mkubon's original design at thingiverse.com/thing:2766908 specifically tailored for the Zumspot on a Raspberry Pi Zero W. The LED hole has been removed and replaced with a Zumspot antenna hole. ...This version is...

This is an innovative 18650 battery case crafted specifically for the popular HRO sold by ZumSpot, which features a 1.3" OLED screen and Pi-0-W computer board. It empowers you to take your hotspot with you wherever you go, or simply use it at home...

I'm going to upgrade the screen and wider hole for a different antenna setup. The display fits snugly, but you may need to lightly scrape or sand the sides for a secure fit. Be gentle when handling the delicate display ribbon to avoid any damage.

This project is designed to accommodate the Jumbospot Pi hat for the Raspberry Pi Zero W, which can be found on eBay and appears to be a clone of the Zumspot. The design was created using openSCAD, making it customizable if needed. To assemble the...

This case is to suit the Jumbospot Pi hat for the Raspberry Pi Zero W found on eBay which seems to be a clone of the Zumspot. Created in openSCAD if you need to customise. Print the 3 parts Insert the Pi into the lower piece Press the insert onto...

This case is to suit the Jumbospot Pi hat for the Raspberry Pi Zero W found on eBay which seems to be a clone of the Zumspot. Created in openSCAD if you need to customise. Print the 3 parts Insert the Pi into the lower piece Press the insert onto...

Case Unveiled: Innovative Zumspot Board Design Features OLED Display Accommodation. The insert and bottom are authentic original parts sourced from G7IMB, while the top section has been redesigned to seamlessly integrate an OLED screen. ...G7IMB retains...

I purchased the standard C4Labs case for my ZumSpot, but soon decided I wanted to install a 0.96" OLED screen inside the case, so I quickly designed a height extender with vent holes on one side. If you examine the picture closely, you will see...

Remix of mkubon's MMDVM HS_HAT cover: https://www.thingiverse.com/thing:2766908 This version features a hole for SMA antenna. On 3/1/2018, the bottom piece was added with "PWR" under the port for power to prevent incorrect plugging of the power...

Human beings can put the ZumSpot case together without needing any screws at all. There are two possible ways to open the lid, one for those who use a Nextion screen and require access to jumpers, and another for users of small 0.96-inch LCD...