xvico 3d printer
1999741 3d models found related to xvico 3d printer.
thingiverse
This is a slightly modified fan shroud for the xvico x1 3d printer. ...This item has a scoop at the bottom to push more air over the nozzle.
thingiverse
The Xvico 3D Pro arrives with a range of impressive standard features, including a high-quality touchscreen interface. However, the fragile ribbon cable located at the back of the display is surprisingly exposed. ...In response, one of the first tasks...
thingiverse
The Xvico 3D Pro come without the touchscreen display cover and the ribbon cable at rear of the display could easily damaged. As a solution you can print such nice protecting cover for the display. No screws is needed its tidily sits on he display...
thingiverse
Designed this spool arm roller for filament for XVICO printers (X3, etc.?). The stock arm is just bent metal which has too much resistance and is too narrow for a few spools of PLA+ I have from Atomic and eSUN. Uses 2x 604 bearings Printing: ...
thingiverse
BL Touch mount for the Xvico X3s. ...Same screws that fit the BL Touch fit the Extruder side and work with this print.
thingiverse
XViCO filament guide for run out sensor NO EXTRA PARTS NEEDED just slides in around the sensor mount Print Settings: PLA 0.2 20 % infill Enjoy !
thingiverse
Simple tool holder to store all the standard tools and SD card reader supplied with the Xvico X3S. ...Simply replace the end cap of the top spar with the tool holder.
thingiverse
Cable chain for XViCO X3S I printed in in PETG but can print in PLA. Printed with all large flat sides down. ... Also requires upper chain 10x11 and lower chain 10x15mm both can be found on Thingiverse or on Amazon.
thingiverse
Designed this in effort to minimize the resistance through the filament feed sensor on my Xvico. Simple 624 bearing roller. Used one of the stock M4 bolts from the sensor block to attach the bearing guide and used two M4 25mm bolts to attach new...
thingiverse
The Xvico X3 is an Ender 3 clone, with a spool holder on top. However it's just a bent bit of metal, and the friction means that the feed is uneven. This build has two end-caps which fit over the existing spool holder, which allow you to mount a...
thingiverse
Simple filament guide for the XVICO Printers to adjust the filament feed rather than printing a new spool holder. ...Simply bolts on top of the filament detection sensor with the standard printer screws.