xconnect connector 3d models
66406 3d models found related to xconnect connector.
thingiverse
... The connector I modeled it on is from [Wired Watts](https://www.wiredwatts.com/3-core-xconnect-connector), but they should all be identical. No supports needed, print two of the mount piece obviously. I recommend printing at 0.2mm layer height.
prusaprinters
I made a mounting device for the popular 3-core xConnect connector. This connector is commonly used for advanced Christmas light displays to music using xLights or similar software. You can see this Instructable I wrote about getting into that kind...
thingiverse
This is a vital accessory for the XConnect model of pigtails utilized in the vibrant world of pixel lighting enthusiasts. Its primary function is to securely connect the female end, shielding it from moisture damage when not paired with its male...
cults3d
This is a male plug and Female cap for the XConnect version of pigtails used in the pixel lighting hobby. This is primarily used to plug the female connection to prevent moisture intrusion when there is no male pigtail attached. ...Also handy to keep...
prusaprinters
clip for the extruded part of the xconnect end. It holds in place with a zip tie. Made for the female end of an xconnect. Slides in over the last bump on the cable and won't rotate, if using 2. Suggestion use 2 and line up the clip end with the...
prusaprinters
This is a cap that covers the female end of an xconnect cable used for Halloween/Christmas LED lighting. Useful for sealing up unused outputs or power injection runs.</p><p>I really liked the original design, but was not completely happy with...
thingiverse
Human: Secure the final connection point at the end of a digital narrative sequence or detach it from the main hub component.
thingiverse
These are replacement female ends with raised numbers to put on your LED animation pigtails before installing them in a controller. They are numbered on 2 sides to make them easy to read, especially if you paint the numbers or print in 2 colors. ...
cults3d
These are replacement female ends with raised numbers to put on your LED animation pigtails before installing them in a controller. They are numbered on 2 sides to make them easy to read, especially if you paint the numbers or print in 2 colors.
thingiverse
I remixed the original design to remove the text as this added unnecessary time and complexity to the print