wpl c24 roof rack 3d models

Roof rack ideal for vintage car miniatures.

roof rack with ladder vtu vid fireman

Roof rack for LR defender 110

p38 roof rack mounting tab 3d scan

traxxas 1\10 summit roof rack

Roof rack for traxxas RC trx4 sport

Roof rack for Land Rover 3D roof rack for Land Rover 3 series dimensions of the roof rack 232mmx129mm the support bars are wider than the Baca

This is end cap for Thule Roof rack. ...

Custom socket to make installing roof rack bolts easier

For La Prealpina roof rack, may fit other models

scx24 jeep roof rack, 4 screws needed for install

Roof Rack Measures Out at 120 by 130 Millimeters

End Caps for a Nissan Terrano Custom Roof Rack mount

Custom Roof Rack system for the WPL C74!This roof rack is designed to clamp onto the rain gutter that runs along the sides of the body no glue needed though this does use a LOT of m2.5 screws but so far I've not been able to break this setup off the...

The roof rails are too short for a standard bike rack so decided to mount the bike upside down and use these printed adapters to align the handler bars to the roof rack rails. Designed to be a snug fit with turtle branded aero roof rails. ... One...

Defoult : C24-1-parts-noramal.stl Mod suspension : C24-1parts.stl Material:ABS filament or UV resin

Axial SCX10 iii Jeep Rubicon roof rack Now also includes V3 low profile roof rack Size 155mm X 165mm Requires four 3mm screws and drill holes in body

roof rack for the Nice volvo f88 www.thingiverse.com/Renngarage/about have made.

Roof rack for 3Dsets model 6 Ranger. This will fit a 158mm ledlight bar. ...

This model is designed as a roof rack for sports cars.

Filler strip secures roof rack by covering exposed channels in extruded bars, eliminating unwanted wind noise.

Roof rack for kayak. ...Fits for: https://www.autodachtraeger.at/aurilis/dachtrager

4 runner roof rack for 5th gen. ...could be modified to fit tacoma.

Roof rack built for 1/10 Axial Capra and this: https://www.thingiverse.com/thing:6142970

Roof rack for 3Dsets model 6 Ranger. ...This will fit a 158mm ledlight bar.

Roof rack for Element rc Trailwalker body.140mm x 81mm x 12mm

Some clips for securing wiring with cable ties under a roof rack. ...The clips slide into the channels on a Frontrunner roof rack (or any rack that takes an 8mm bolt). ...Printed 100% infill, no support.

This is a custom designed flat bed with full rear roll cage for the WPL C24 & C14 remote control rock crawlers. It also includes a fuel cell that covers the battery and a spare tire mount. Hardware required: (2) 2mm x 10mm screw to hold the...

SCX24 GLADIATOR LUGGAGE RACK ATTACHES TO THE ROOF WITH DOUBLE-SIDED TAPE NOT SCRATCHES IN THE BODY

MN D90 Roof Rack Uses the existing mounting holes easy print print without supports print 4x the mounting pin stl