wire soldering holder 3d models
456303 3d models found related to wire soldering holder.
Artillery Sidewinder X1 / X2 / Genius TFT FW + Marlin FW (for X1) + M600 support + Marlin mode (optional)
thingiverse
thingiverse
to OctoPrint) is wired to a serial bus. This bus is also shared by both TFT and mainboard. The sharing of the serial bus does not allow to easily flash Marlin firmware due to collisions in the bus. Two possible solutions were normally adopted to...
Modular honeycomb coffee table with built-in storage and pop-up light
prusaprinters
prusaprinters
Remove the wire arms after inserting the binder clip. The bottom of the hex bodies will only be attached to the base surface, by screwing them either from within the body into the base surface or, through the base surface into the hex...
Prusa MK3/s *Mono Linear Rail* Upgrade
prusaprinters
prusaprinters
Sie werden Später noch benötigt.Demontage Z-AchseNun müsst Ihr alle Elektrokabel und Lüfter durch die alten Lagerstangen nach hinten fädeln so das nichts mehr in der X-Achse hängt.Ebenfalls wäre es Ratsam jetzt den Motor der X-Achse abzubauen oder...