washburn d10 3d models
813 3d models found related to washburn d10.
prusaprinters
Solder a cable to every spot, but be careful so that you solder them from the backside and not from the front.VCC = 5V+GND = GNDDIN = D10CS = D11CLK = D12Trigger MechanismCut two cables and only prepare one side of every cable for soldering. Solder...
thingiverse
Connect the SD Card Reader wires: |Sensor Wire|Breadboard Row| |---|---| |GND |ground row created in step 7| |VCC | 5V row created in step 7| |MISO | Arduino pin D12| |MOSI | Arduino pin D11| |SCK | Arduino pin D13| |CS | Arduino pin D10| ![SD...
cults3d
Thermistor goes to T0, heater to D10. Fan to permanent 12v, so it’s on all the time. Make sure when you heat it up the heater block reads the same temperature or as close as possible to the temperature you've asked for. Since PID helps with hot ends,...