warp reactor 3d models

The hands can be set simply by turning the minute hand.The weight drops at a rate of about 7cm an hour, so you need at least 180cm of drop for the clock to run for a full day.See this video for it in action: This was printed in PETG, my...

Especially the Body is suspect to warping due to many overhangs.Known Issues: can I fix my problem?Hammer stops half way: adjust nose of Hammer-Rotator until it can slip over the teeth of the Cylinder-Rotator.Cylinder spins over the notch, resulting...

The resolution/aspect ratio when streaming was also tricky to get to work correctly with my PC to remove "black bars" on the top and bottom of the screen and to fill the screen without having to use the "stretch" setting in Moonlight, which would...

Avoid lifting and warped prints!There is a small amount of support needed - "for support enforcers only."Under the elevator shaft on the Middle Floor and Top Floor.The elevator door on the base floor.Increase the size of your “Dice Tower - Building...

Avoid lifting and warped prints!Print all three parts (body, treads, roof option.)Superglue the treads to the body.Choose the roof option and glue, or leave it free and swap it out as needed!Superglue works best for gluing it together.It will scale...

Avoid lifting and warped prints!Print as many as you need!Rinse and repeat!Don't let them win! Take what's theirs and make it your own! ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~More fun...

If all lights are set to white with full power the clock uses 4 amps of current (20 watts), which is enough to create heat that is capable of warping PETG. Also if the clock is placed somewhere where the sun hits it, it will most likely get very hot,...

Less deformities in the tape is better as it will increase adhesion and lower model warp. --- --- ###### PowerBelt Belt Installation From the folks at PowerBelt: https://youtu.be/ShYZX8OavIs I will also note here that it can be helpful...

*Note I've noticed that upon updating Cura that support generation varies between versions so you may need to tweak support overhang angles from posted values below - make sure to do a preview to check for proper support and alter as needed - values...

print with, so.... If you print almost everything in PETG with 2 mm shells, using 40% triangles infill, and print the blower nozzle in ABS using the lightest settings that still produce a usable part (since it needs the heat resistance and won't be...

If all lights are set to white with full power the clock uses 4 amps of current (20 watts), which is enough to create heat that is capable of warping PETG. Also if the clock is placed somewhere where the sun hits it, it will most likely get very hot,...