vanmoof rear rack 3d models
82501 3d models found related to vanmoof rear rack.
thingiverse
Designed for cutting with a last cutter and then the 3 layers glued together. ... The layer with the cutouts for the hex nut goes in the middle and a little glue can be used to secure the bolts in place, which allows the whole base to be mounted nicely...
thingiverse
Customized version of https://www.thingiverse.com/thing:3854684 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=3854684
thingiverse
Customized version of http://www.thingiverse.com/thing:263648 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=263648 Instructions Using the following options: thickness - set to 6 mm for a sturdy...
youmagine
Print out, remove the support from the slide, test fit with the Fly6. Make sure it's snug enough not to fly off, but still easy to slide home without getting stuck. I ALWAYS advise secondary tethering of gadgets. To do this on the Fly6, pull out one...
thingiverse
Remodelled to improve the (V300 etc) fit on this smaller print, saving a tiny bit of weight and print time. Print in PETG for strength and longevity. Red translucent shown. Built in support is provided within the print to allow easy printing.
prusaprinters
Remix of the Vanmoof/Ortlieb Pannier Bag Wall Mount by PjotrStrog to hang bicycle bags on a Multiboard or a Honeycomb (HSW). You need two MultiConnect connectors, e.g. ...Multiconnect - Board connectors_Multiboard big, laying down, horizontally next to...
cults3d
Very simple rear spoiler, easy print-in-place. No gluing etc. ...Can be glued to cars or similar things.
prusaprinters
<p>Cut the 3 parts from the original mounting plate.</p>
thingiverse
Wall mount holder for charger of the Van Moof type S3/X3. ...Can be mounted with 3 universial screws.
thingiverse
Customized version of https://www.thingiverse.com/thing:2749579 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=2749579