unneeding 3d models

 For stiffer cables, you will want thicker walls, but keeping them thin is important in terms of efficiency (if you're making dozens of them).You may want to crank up $fn from its default value, or PrusaSlicer may try to add unneeded gap fills...

setup I tought about is powerIn, lineIn and chaining)Included are the following push-in pieces:For powersocket 5,5mm (2,1mm Pin) external screwedFor powersocket 5,5mm (2,1mm Pin) internal screwedFor LineIn (jack) socket 3,5mm external screwedFor...

I did this to try to save some unneeded plastic. Also make sure the material, infill, and layer height are set properly for your print. I recommend using a layer height of 0.15 and and infill of 10% to 15%.If you have not used an amf file in...

Nelly the Deepborne Kraken Before Samira reactivated the Krakencaller trident, ”Nelly” had been inactive for centuries, unwilling or unneeding to surface, subsisting on a diet of krill, plankton, and small sea creatures swimming too close to her.  ...

The other two clips without cut-out / phase are intended to be used as spacers or to hold other parts than bearings in place.With these clips it is possible to freely adjust the position of the pulleys, remove unneeded clips e.g. when you want two...

Remove unneeded vinyl from the windshield. After theWindshield Adapter has fully cured, carefully twist your new rearview mirror onto it, holding the base for stability. <a href="https://i.imgur.com/prkmA8W.jpg">Check that your camera is centered in...

We originally created a smaller sketch alongside but it was unneeded and solely for an idea of what the original size was. Keeping the scale of 2X would be beneficial later down the road as it is easier to read and when needed easier to change and...

Remove unneeded vinyl from the windshield. After the *Windshield Adapter* has fully cured, carefully twist your new rearview mirror onto it, holding the base for stability. [Check that your camera is centered in the trapezoid...

(Note that the bar in the pics has unneeded holes drilled in it - this is an older bar I had around)Insert two m3 hex nuts into the two pocket holes in the Central Arch (there is one in the back and one on the right side).  Do not force the nut in...