turbo drag axle 3d models

Now drag everything around so it fits on the bed. If you get "toolpath detected outside build volume" errors when you slice, set the Skirt Loops to 0 in the print settings.</p><p>See below for what you should end up with if you've done everything...

While fighting the beast, he got stuck in a rubbish heap and was dragged through the filth, and after striking the killing blow, the beast's slime and bile spilled all over the witcher, adding to his stench. After returning to the inn they were...

I think it's obvious where it goes :-) (there's no fitting pictured here, as I don't use one). Use a suitable drill to clean up the small gear's axle hole, if necessary, add an M3 nut to the nut trap on the bottom, and thread-in 6-8 mm pan- or...

That's a drag queen! What is this? Oh, no! There's hundreds of them! Bee honey. Our honey is being brazenly stolen on a massive scale! This is worse than anything bears have done! I intend to do something....

Also, I've been wanting to try T-thread screws as axles for filament spools for a long time. Metric nuts and studs are not very suitable for this purpose, as they stop quickly when rotating, they simply go into resonance. T-nuts, on the other hand,...