triceratops outline 3d models

with a 0,15 height, set to 10 to have a 1,5 mm solid layer Outline/Perimeters Shells: depending on Extrusion Width. E.g. with a 0,50 width, set to 3 to have a 1,5 mm perimeters shells * First Layer Height: set to a value greater than 100% to have a...

I used a light green for the stem and leaves, and red for the pot. All parts were printed with the following parameters: 0.2mm layer height 2 outline shells 3 base layers 3-5 top layers 5-15% rectilinear infill Servo Preparation This projects...

The  spools and buffer setup outlined here sit on the left side of the desk, behind the printer also facing to the right.   (You can also have it all face to the left instead.)There is a 9 inch gap between the printer's back frame and the base board...

with a 0,15 height, set to 10 to have a 1,5 mm solid layer Outline/Perimeters Shells: depending on Extrusion Width. E.g. with a 0,50 width, set to 3 to have a 1,5 mm perimeters shells - First Layer Height: set to a value greater than 100% to have...

I also did not bother with the fixing features as I could screw together the Bodies.Irrespective of the build material, all modules should be secured to a flat surface (again, I used 9mm plywood) cut to roughly the overall shape (smaller by about...