tft ekko 3d models

Hardware : STM32F103 Blue Pill MCU , ST7735 1.8" TFT display, RFID-RC522 module, Li-Ion phone battery, TP4056 charger board, micro SD, DS1302 RTC optional. 3D parts : hinge for RC522, charger PCB holder, STM32 PCB holder, keyboard (not...

I use a SKR 1.4 Turbo, 3.5 TFT, 2209 drivers, Mellow NF-Crazy hotend, BMG style extruder, direct drive, and sensorless homing. ***You break, modify, breathe on, glance at, or even think about your printer, you're responsible for any...

You can also just use the 10mm belt and get yourself two more pulleys. fan duct got its own thing: https://www.thingiverse.com/thing:4879201 TFT_frame_bracket allows you to mount the https://www.thingiverse.com/thing:4551454 on the frame edges. The...

This also reduces cable distance to the TFT screen, usually mounted on the front left corner leg, and provides best access to the SD and USB ports on the mainboard. After that, the decision is what to do with the power supply. Personally, given...

A full breakdown is covered below: - TFT 35 Case: Simple case, similar to the many out there. Has mounting bracket and holes to mount to standard 2020/2040 rails at bottom of printer frame; facing upward. - SKR 1.4 Turbo Board Box: SKR 1.4...

The "solution" is then to Dremel out a few pieces of metal to expose the SD/USB of an SKR/MSK board. I don't like irreversible changes so I will not alter my case. But I do want to access the SD card for firmware changes. The USB I don't need because...

This is the part used: "2.4" 240x320 SPI TFT LCD Serial Port Module+3.3V PCB Adapter SD ILI9341" 3. You will need 4x 3mm wide (m3) x 10mm screws to hold the upper & lower case together. I use m3x10mm Thread forming / self tapping screws because all...

And this is the result: See also: https://www.thingiverse.com/thing:4437154 https://www.thingiverse.com/thing:4973689 https://www.thingiverse.com/thing:5835589 https://www.thingiverse.com/thing:5827637 https://www.thingiverse.com/thing:4409466 Parts...

Note TFT cable routing shown in last two photos, to avoid the screw boss. Changed minimum suggested bolt length for attaching Rear component to Back.</p><p><strong>Updated 2021-10-15 / 2021-10-16:</strong></p><p>• Added "TFT35-E3_Front_rev3_cut.stl"...

This is the part used: "2.4" 240x320 SPI TFT LCD Serial Port Module+3.3V PCB Adapter SD ILI9341" You will need 4x 3mm wide (m3) x 10mm screws to hold the upper &amp; lower case together. I use m3x10mm Thread forming / self tapping screws because all...

 Clearance for the DSI ribbon to the BTT Pi TFT V2 is acceptable:  Installed on DIN rail:...

I've upload the remix as a separate print.M2.5 brass hex stand-off kits found on Amazon.I had to make up a stand-off to get 16mm height, which provided an ideal seat for the HAT on the GPIO pins.The remixed mount allows for M2.5 nuts to be inserted...

and bought another controller along with an autonomous controller, so as not to use the computer for engraving, because the laser is such a thing that there is a lot of smoke from it, and it is better to take it away while it is working ... The main...