temp tower petg ender 3 3d models
795181 3d models found related to temp tower petg ender 3.
thingiverse
Customized version of https://www.thingiverse.com/thing:2615842 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=2615842
thingiverse
Customized version of https://www.thingiverse.com/thing:3438677 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=3438677
thingiverse
Customized version of https://www.thingiverse.com/thing:2615842 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=2615842
thingiverse
Customized version of https://www.thingiverse.com/thing:2922338 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=2922338
thingiverse
Just a simple temp tower to use for PLA or any other material in the 190-230 heat range. Sized and sliced to work with the ELEGOO Neptune 3 Plus, should work just fine with the Neptune 3 Pro and Neptune 3 Max. ... I included the untouched .stl of the...
thingiverse
Bed Clip for Ender 3 Bed Glass After testing some existing designs that weren't quite tight enough, I decided to create a custom solution. This design should fit most Ender 3 beds. **Important:** To ensure the best results, print this clip with PETG...
thingiverse
To block this air on the first layer, I created this concept (for the Ender 3). I must print the first layer at a max of 10mm/s. It's enough to disassemble the hotend casing and slide in the largest piece inside, which fits onto the casing and...
thingiverse
I've decided to share with you the print profile that I use for PETG in Ideamaker because finding a baseline setting for Ender 3 online was a major challenge. After struggling through several attempts, I finally managed to create one and am now...
thingiverse
This is the same tower but the gcode is for an Elegoo Neptune 3 from the Elegoo(Cura) Slicer. ...