sv02 3d printer
1981089 3d models found related to sv02 3d printer.
thingiverse
i needed a replica of the Sovol SV02 fan shroud so i could make room for an endoscope camera. i could not find one so i tried to make one myself. i am a beginner in 3D modeling but the shroud fits. ...i upload my design in case someone needs one.
thingiverse
this is a modified print from Daniel Otto (thanks!!!) i had to change the top left to make it work on the sovol sv02 note: the height will have a small limit change, my printer limits out at a height of around you will need some extra hardwear, but...
thingiverse
My take on a DD mod for the Sovol SV02 printer, reusing the standard extruders and steppers. This was originally based on a design that no longer seems to be on here by Daniel Garrett. There are two versions. ...Both include BL Touch mounts, with the...
thingiverse
Remix of the SV02 + Mk8 Fan Mod, made in TinkerCAD I found that the original was too big and left no clearance, so these are a bit shorter.
thingiverse
Designed this for the SV02 when I changed it to direct drive, using concepts from a couple other filament guides. My SV04 IDEX has runout sensors which keep the filament neater when printing and wanted similar for the SV02. There are two styles...
thingiverse
This is a remix to fit the Sovol SV02. You have to mirror one for the other side. It fits pretty well but it's tight. There is enough play in the two screws that hold the fan assembly to get it level and aligned with the bed. These will hit your...
cults3d
This is a remix to fit the Sovol SV02. You have to mirror one for the other side. It fits pretty well but it's tight. There is enough play in the two screws that hold the fan assembly to get it level and aligned with the bed. These will hit your bed...
thingiverse
This is a filament guide into the extruder for the Sovol SV02 for the left and right side. It is hollow with a big enough diameter for standard ptfe tubing. It's not perfect and you may need a piece of tape on the metal to keep this part from moving....
thingiverse
Remixed for dual extruder Sovol SV02. End clip redone to accommodate different gantry configuration. Guides made shorter for more confined area and to compliment the filament roller guides by MX-Trainer (https://www.thingiverse.com/thing:4681978). ...
prusaprinters
... screws, 2 M3 washers, and 2 M3 nuts.The M3 washers go between the M3 screw and the bl touch mount. ...The washers are for the 2 screws that attach the mount to the 3d printer.The M3 nuts are supposed to go below the bl touch to secure it to the mount
thingiverse
SV02 Direct Drive Mod Using Original Parts Sv02 Direct Drive Mod Using BMG Extruders and Pancake Motors
thingiverse
A small conversion of my SV02 from the original heating block to a standard MK8 heating block. ... The MK8 is 5mm higher than the original, I designed adapted parts for the component ventilation and a mount for the bltouch.
cults3d
This is a mount adapter to permanently mount the 5W Laserhead and the standard BLTouch sensor simultaneously to the two screwholes on the SV02 mount plate. Versions differ in length to accomodate Mixing or standard dual-extrusion hotend All...