stryker nbcrv lp 3d models

Another issue we came across was that our original plan did not involve using the offset entities feature, which was a requirement for this project. We were originally going to use basic shapes to create the left side of the mouth, then mirror...

There are loads of problems, but the big ones are just human error in measurements and the fact that the 12" LP standard is not actually 12" in diameter, it's slightly smaller. That is enough to cause an issue. Get it professionally done or use a...

This can be done with a breadboard to avoid soldering; using the perf board.Here is the Arduino...

Here's a general run down of the parts that I used to build this (keep in mind that these are bottom shelf cheap parts so they may go in and out of stock as time goes on).  Strap ButtonsAmazon.com: Musiclily Metal Guitar Strap Buttons End...