squink tft 3d models

This is the part used: "2.4" 240x320 SPI TFT LCD Serial Port Module+3.3V PCB Adapter SD ILI9341" You will need 4x 3mm wide (m3) x 10mm screws to hold the upper & lower case together. I use m3x10mm Thread forming / self tapping screws because all...

Note TFT cable routing shown in last two photos, to avoid the screw boss. Changed minimum suggested bolt length for attaching Rear component to Back.</p><p><strong>Updated 2021-10-15 / 2021-10-16:</strong></p><p>• Added "TFT35-E3_Front_rev3_cut.stl"...

I've upload the remix as a separate print.M2.5 brass hex stand-off kits found on Amazon.I had to make up a stand-off to get 16mm height, which provided an ideal seat for the HAT on the GPIO pins.The remixed mount allows for M2.5 nuts to be inserted...

and bought another controller along with an autonomous controller, so as not to use the computer for engraving, because the laser is such a thing that there is a lot of smoke from it, and it is better to take it away while it is working ... The main...