spiderman half faceshell 3d models

Apparently the rotor stops in a position where it has, so to speak, a half-dead magnetic field (I think so, maybe I’m wrong) ... But in principle it works ... But sometimes you have to start by turning the rotor, and this is inconvenient, of course,...

This happens every time the Z-axis shafts stop rotating after two and a half seconds. And do not worry about the memory resource (read / write), although the Arduino claims one hundred thousand cycles, but I implemented this process in such a way...

2021/9/30: The forehead half model was missing its details. I have corrected this. Additionally, I split the original 'MCOR Helmet Skull Cap.stl' file up so that the dome portion is now separate from the side panel. This makes this piece easier to...

This is brief, in more detail in the video.The basic parameters of the module can be read on the seller's page, and there are many reviews on YouTube.Of course, if I had done this device not on camera, everything would have gone quickly and smoothly,...

Attach the belt to the belt clip in the upper half of the printed carriage, then run it up and over the idler pulley at the endstop holder, then back down through the left side of the carriage, around the motor pulley, then back to the printed...